View Profile: NSEGE - XCR Forum
Tab Content
  • NSEGE's Avatar
    03-15-2017, 06:03 AM
    NSEGE replied to a thread New XCR-L Break-in? in Problems
    Nope.... Federal GMM and Hornaday factory.
    9 replies | 161 view(s)
  • NSEGE's Avatar
    03-14-2017, 06:18 PM
    NSEGE replied to a thread New XCR-L Break-in? in Problems
    Since the Sierra's chamber and a loaded round extracts fine, it's not the chamber. looks like a short throat...distance from the end of the chamber...
    9 replies | 161 view(s)
  • NSEGE's Avatar
    03-14-2017, 02:26 PM
    NSEGE replied to a thread New XCR-L Break-in? in Problems
    I tried Sierra 69 and 77 grs and it worked beautifully. Cycles fine on the "2" setting (Type 3 gas block), so obviously the problem is with the...
    9 replies | 161 view(s)
  • NSEGE's Avatar
    03-14-2017, 10:49 AM
    NSEGE replied to a thread New XCR-L Break-in? in Problems
    Haven't tried a lower gas setting yet just following the break-in directions so far. I did run a Sierra bullet into the chamber and it shows the...
    9 replies | 161 view(s)
  • NSEGE's Avatar
    03-14-2017, 09:42 AM
    NSEGE started a thread New XCR-L Break-in? in Problems
    I just got the XCR-L competition rifle, and took it to the range yesterday with Hornaday 55gr soft points. Lubed it up well, opened the gas system...
    9 replies | 161 view(s)
No More Results
About NSEGE

Basic Information

Statistics


Total Posts
Total Posts
5
Posts Per Day
0.33
General Information
Last Activity
03-15-2017 06:03 AM
Join Date
03-14-2017
Referrals
0