"Necessity is the plea for every infringement of human liberty. It is the argument of tyrants; the creed of slaves."-William Pitt the Younger
it's one of those times when i have to just relax and wait till i get it in the mail.
i am going to buy those ASC Mags to try out in 5.45x39 as they have 2 for $23 on their site.
he must of had to Manufacture mine because they did not leave El Paso
until the 8th day after i ordered which was 8-14-2020,
but only 3 days to actually travel to my address.
They look Good, and i will try and Test them ASAP.
btw.....just seen bulk ammo prices rise by another $20-30 per 1000 today
for the 5.45x39 and 7.62x39
loaded up some 5.45x39 in one of the Unimags and got 26 in out of the 29 advertised, but i just did not want to force them at first.
Then manually with my fingers stripped them out one at a time to see how they might feed out of the Unimag...not the smoothest.
Then loaded 7.62x39 into the Unimags and fully loaded the advertised 25, and then stripped them out with finger.
Either Caliber was not as smooth to load, or to strip out as i thought they would be.
But i am sure they will do as they should with the BCG stripping them.
btw...the first Unimag i opened, and the only one i tested for now fit into two different Lowers.
One is Anderson, and the other is a Polymer lower of some sort, which i had on hand.
Actually that is what the floor plates say, as i have not looked at the body closely yet.
I will post what i see tomorrow on the Bodies, but quick check
on the one i opened there is no dates like on the floor plate.
i will check better when i post tomorrow.
Last edited by Bobby; 08-17-2020 at 07:32 PM.
There are no dates except on the floor plate, but there are other numbers.
On the Right side as if the Magazine were loaded into the Lower it says FCF-18.
On the Left side as if the Magazine were loaded into the Lower it says FAE-18 , and the Patent Pending #