Top down mag well
I have tried screwing it in to the point were threads are sticking out of right side mag realease.
The catch looks out of tolerance - too short - not extending enough into the magazine well.
"Be Vigilant and Safe!!"
"It Is A Weak Man Who Urges Compromise!!"
Merlin that what I was thinking. But wanted y'all experts insight.
So any chance getting a new mag release or one that fits the type 0.?
How thick (wide?) is your mag release?
ETA, I measured four. 2 of them were .201", one was .202, last was .205
Last edited by navalbeaver; 09-17-2018 at 08:18 PM.