XCR Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
636 Posts
Discussion Starter · #1 ·
I recently bought a new gas block. (Thread "Failure to Cycle" in the Problems :() I sent back the gas block & barrel to Terra. The gas block was bad (out of spec). So she replaced the gas lock and had the barrel refinished. And shipped it back out the same day. I shipped it to her on 06-12 dot it back on 06-18. In my book that is +A+ customer service.

So today 06-20 I took it back out to the range. I brought some Wolf and IMI. On setting #2 it was ejecting casings about 10-12 yards. I went to setting #4 the casings went about 10 yards. Then I en back to #2 and then they went about 14 yards all @ 2-O'Clock. They only Problem as that the safety selector switch came off. The bolt came loose then off I found them And put the back on. No big deal, I will just loctite it later today. No jams, failures. The only real problem I had was not enough ammo.

Again a big thank you ;D to Terra.

Jason
 

·
Registered
Joined
·
923 Posts
"The only real problem I had was not enough ammo. "

That is the worst problem with this weapon
 

·
Registered
Joined
·
636 Posts
Discussion Starter · #4 ·
"The only real problem I had was not enough ammo. "

That is the worst problem with this weapon

I know. :duh:

I only had one 20rd & 6 30rd mags. What is a man suppose to do? :-\
 
1 - 5 of 5 Posts
Top