XCR Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13 Posts
I had the same problem.

I cut a wave spring into 20 degrees less then a full circle. I then placed it over the gas block gas tube port and up to the gas tube. The spring holds the gas tube in place, yet allows it to move if it has to. Now I don't have any rattle in the gas tube.

My adjustable gas port rattled as well but I used an AR-15 gas ring and trimmed it a bit and placed it in the adjustable gas port and now that does not rattle ether.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top