XCR Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
431 Posts
Discussion Starter · #1 ·
Ok my question is primarily on the barrel, Im not sure what Im doing wrong but when I clean it,
First I use the wire bursh attachment.
Second solvent dipped cleaning patch.
Third dry cleaning patch.
and I repeat but my patch will never ever come out completly 100% clean... unless I cheat and use like 4 drys in a row, but then if a put the brush and solvent patch its dirty again, I went through a whole bag of patches once, so I have to be doing somthing wrong and yes I clean once I get back from shooting and no its not just the solvent making it look dirty... I've searched the whole net and all any thing says is "run patches with solvent then dry and repeat untill it comes out white." Ive been cleaning like this for years and never get a barrel 100% thiers always somthing in the riflings...
So any advise would be great...
 

·
Registered
Joined
·
431 Posts
Discussion Starter · #3 ·
I just ran a patch over my rod and thats not the problem...
 

·
Registered
Joined
·
431 Posts
Discussion Starter · #6 ·
Actually Im piss broke so Im just shooting my 10/22, and its cold so I dont stay out long... Those things get dirty, not so bad with my new ammo though remmington is crap... federal is great thanks for the pointers ;D
 

·
Registered
Joined
·
431 Posts
Discussion Starter · #8 ·
thancks for the ideas, Ill put them into practice ;D
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top