XCR Forum banner
1 - 1 of 1 Posts

6,537 Posts
This is my usual routine:

1: Dry brush first to get the worst of the mess out, followed by some spray solvent.
2: Boresnake twice
3: Alternate patch on a jag with wet solvent and two drys, until I'm happy.
4: Patch with 90% alcohol to kill any remaining solvent in the rifling. If this comes out dirty I repeat step 3.
5: Patch with oil.


Doing this so far means that my cold bore shot has the same zero as subsequent shots.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.