XCR Forum banner
1 - 1 of 1 Posts

1,038 Posts
Here is what works best for me:

1. Solvent on brush - like wristlock said - about 10 times
2. Patch/solvent/patch - clean rod - repeat as needed
3. Bore snake it a couple times

The bore snake seems to finish it off for me - getting that last bit of residue out, and finally...

4. I use Militec as the final bore swab

So far, I get great results.

I'm sure others have different cures, but this is what works for me.

Good luck!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.