XCR Forum banner
1 - 2 of 2 Posts

· Registered
39 Posts
Remember the bolt locks into the barrel extention when rounds are fired. This means the quick change barrel screw only needs to hold the barrel from moving between shots so groups are not all over the place. No need to be the HULK on the screw... just use a standard 1/4" hex and without a cheater bar and you will never break anything. No need to over tighten it..
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.