XCR Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
5,071 Posts
I did a couple AK's but bought my recievers from NoDak. Rivets and all and it was fun as hell! I did get something misaligned in the shop press and had a barrel pin tool go shooting across the garage like a meteor though....oops.

Pics!!!!
 

· Registered
Joined
·
5,071 Posts
I used the bolt cutter tool for my first one then splurged and got one of the AKBuilder rivet jigs. Slicker than snot. Can't remember where I got the T/G jig, but it wasn't more than $20. It sure is fun though! I've got an underfolder to finish one of these days.

Can't wait for the pics!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top