XCR Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I recently picked up a new 7.62 xcr. I haven't had a change to really get in to it or fire it yet, but I noticed a potential problem between the upper and lower receivers. Where the upper meets the lower back by the stock the upper sticks out to the left almost a 16th of an inch, and is recessed on the other side. The receiver lock is seated properly, and they remain locked tight until the button is pressed. Is this a problem?
Any insight would be greatly appreciated.



 

·
Registered
Joined
·
6,835 Posts
Nope, not at all. It is designed that way and if I recall correctly Terra posted about it somewhere. You will be just fine. Take lots of ammo and go have fun.
 

·
Registered
Joined
·
5,071 Posts
They all are offset to some degree. I think it was something to do with ensuring the charging handle didn't catch on the receiver.
 
1 - 7 of 7 Posts
Top