XCR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
So I did a quick search and couldn’t find anything about this topic before doing this post. Although, I imgine it has probably been talked about before.

I recently picked up a, new to me but used, keymod hand guarded version of the XCR-L. But, I noticed pretty quick that I can’t get the barrel out with rail sections attached. I’m pretty sure it’s the thin barrel but it is 6.5 grendel. It gets caught up at the chamber. Does anyone have a good brand of keymod pic rail that might have shorter screws that would let me get the barrel out without having to remove the keymod rail sections? I grab a rail section from PWS, haven’t tried another brand yet but was thinking about order a BCM rail section, Thanks.
 

·
Registered
Joined
·
22,085 Posts
I don't have any rail sections...but I have a BCM KAG that sits on the lower portion of just about all my XCRs and the bbls come out without any issues.
 

·
Registered
Joined
·
21 Posts
So I did a quick search and couldn’t find anything about this topic before doing this post. Although, I imgine it has probably been talked about before.

I recently picked up a, new to me but used, keymod hand guarded version of the XCR-L. But, I noticed pretty quick that I can’t get the barrel out with rail sections attached. I’m pretty sure it’s the thin barrel but it is 6.5 grendel. It gets caught up at the chamber. Does anyone have a good brand of keymod pic rail that might have shorter screws that would let me get the barrel out without having to remove the keymod rail sections? I grab a rail section from PWS, haven’t tried another brand yet but was thinking about order a BCM rail section, Thanks.
Arisaka low profile rails are your friend
 
1 - 4 of 4 Posts
Top