XCR Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
;D

Well sorta.

I pulled a lever, undid two bolts and BAM! Look what happens!!!!! :eek:



Sending the receiver out to Bill for a trigger job and figured wth lets pull the barrel off to. It's amazing how this gun come apart!
 

·
Registered
Joined
·
6,835 Posts
You wont be unhappy with the trigger, that is for sure. I am amazed at how easy this thing breaks down every time I take it apart.
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #4 ·
I'm also impressed with the little things; the retaining clip thats fitted into the lower for the front take down pin, the hammer pin has one to. the gas system is so simple but so well done. Nice job Robinson!
 

·
Registered
Joined
·
2,200 Posts
If Majic is too far away, that will save on shipping, I volunteer to shoot it on my backyard range until it self destructs. ;D
 

·
Registered
Joined
·
923 Posts
Is that a streamlight TLR-2 ? If so how does it work ? Is it easy to adjust ? How far does the laser go out to ?
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #12 ·
Is that a streamlight TLR-2 ? If so how does it work ? Is it easy to adjust ? How far does the laser go out to ?
Ya it's a TLR-2, I like it,

Light is good, just as bright as my Surefire X200, I understand the new x300 is brighter but it's also almost as spendy as a TL-2 with out the laser.

The laser is easily seen as far as I can see in any light condition in side the house. Out doors in the sun it fades prity quick, 25 meters tops on a light surface. Dusk /overcast 50. At night it will light up trees at 100 and reflective objects (street signs) at 200.

I have it set up with a pad in the TD grip.

Biggest bad is you have to dismount the light to change the batteries, but thats my only gripe. You also need the light, an adapter and then a remote pad if you want to use a remote, I wish they just had a package but not the end of the world.
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #13 ·
Couple pic's of the other side you can see how I did the cable run. I put a couple bands of electrical tape on it, fit great I just wanted to protect and hold the pad more.



 
1 - 13 of 13 Posts
Top