XCR Forum banner

Perfect tool for the XCR

4474 Views 10 Replies 8 Participants Last post by  SDDuc996
I'm probably the last guy to figure this out :duh:, but this tool is a great companion to keep with your XCR. I'm sure they can be found just about everywhere, but this one was $5 at Lowes.



It has every hex size for the XCR including the 1/4" for the barrel bolt. The only thing missing is a wrench for the ejector bolts.

I finally got tired of digging through my bag of old school hex wrenches looking for the right one.
See less See more
1 - 11 of 11 Posts
Doesn't the barrel bolt (and maybe some others) require an exact torque spec be applied, i.e, you need a torque wrench?

I've actually been meaning to inquire about a good one that lends itself to use with the XCR.
Doesn't the barrel bolt (and maybe some others) require an exact torque spec be applied, i.e, you need a torque wrench?

I've actually been meaning to inquire about a good one that lends itself to use with the XCR.
Nope hand tight then extra 70 degrees....
Doesn't the barrel bolt (and maybe some others) require an exact torque spec be applied, i.e, you need a torque wrench?

I've actually been meaning to inquire about a good one that lends itself to use with the XCR.
Per Terra...
200 in. lbs. (or about 17 ft. lbs.)
I have actually been looking for something like this, but I want one that will fit in either the storage compartment of a MIAD or my Tango Down VFG. I don't think it's possible unless you have one custom made with just the sizes required for the XCR to keep the size down. If Robinson had some made I'd buy it. :hint, hint:
I made a wooden tool out of some scrap to hold the upper and lower open on my cleaning cradle. Works similar to the link device made for the AR15 that holds the upper and lower open when cleaning.....now, if one of these days I can get to the range to shoot, get the rifle dirty and clean it...I can test my invention out ;D
Yeah but where's the beer bottle opener?
You mean you don't already have one on your key chain?!?

Get with the freakin' program SDDuc.
2
I chop and change between this one (Husky 30 pc ratcheting hex driver from Home Depot)



And this one, the Leatherman tool adaptor where I have swapped out the bits.

See less See more
Does anyone have a torque wrench they like to use on the XCR?
GI Bro, like the old saying goes, two is one...
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top