[admin]

What spare parts would you recommend to always have on hand?

What do you think is the first thing that will get worn out and will eventually need replacing on the XCR?

I would like to order some parts to have in case something breaks or wares out, so what would you suggest?

 

[UDT]

JMO, but I would recommend the following spare parts:

Gas Block Allen Screw
Gas Valve Nut Lock Washer
Barrel Bolt
Ejector
Ejector Fastening Bolt (2)
Lock Washer for Ejector Bolt (2)
Hammer Spring
Main Pin
Recoil Buffer
Trigger Axis Pin
Trigger Spring
C Clip for Op Rod Spring Guide
Recoil Spring
Extractor
Extractor Spring
Firing Pin
Firing Pin Roll Pin

It may look like a lot, but it is always better to have too much than not enough. Hope this helps answer
your question.

 

[admin]

It may look like a lot, but it is always better to have too much than not enough. Hope this helps answer
your question.

Yes! Thanks!

 

[jim137]

Someone should get Robinson arms to put together a kit like above and offer it for a discounted price.

 

[UDT]

Someone should get Robinson arms to put together a kit like above and offer it for a discounted price.

They are working on a parts kit, but I do not know what it will contain or just when it will be out.

 

[Grey]

I would really like a parts kit as well. But until then I may just order parts from the robarm site and assemble my own. UDT, thanks for the list.

 

[UDT]

I would really like a parts kit as well. But until then I may just order parts from the robarm site and assemble my own. UDT, thanks for the list.

My pleasure and welcome to the forum.

 

[kolob]

We've been asked a gazillion times what spare parts do we recommend. We designed and tested the rifle to see how durable it is. We got it so it just doesn't break parts. However, we have had a few firing pins break and a few hammer springs. All were defective and broke under 2000 rounds. Oh, we had one rubber recoil buffer break.

So, we're going to put all the parts (that's each and every part) on our website. You can order what you want. But don't expect to need lots of different parts. We will make some spring, bolt, and pin kits simply because you're likely to loose them.

Sincerely,

Alex J. Robinson
Manager