XCR Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,296 Posts
Discussion Starter · #1 ·
Let me get this place warmed up (so to speak)....

I want to give bullet casting a shot. When I was a teenager, and too young to legally own cartridge pistols, my buddies and I all owned cap & ball revolvers, and I used to cast balls for us. It was almost as much fun as shooting the pistols.

So 30 years later, I'm ready to try again. I'd like to start with 9 mm. Any recommendations on specific bullet molds or on specific mold makers? My round ball molds were from Lee, but are aluminum molds the best way to go? They're certainly the cheapest. I would think that I'd need at least a two-cavity mold to make a decent quantity. You thoughts?

tk
 

·
Registered
Joined
·
3,296 Posts
Discussion Starter · #6 ·
Guys,

thanks for the otes. I'll get a lee mold to start and check out castboolits.


Charliea,

where do you get cast bullets for $60 per thousand?

tk
 

·
Registered
Joined
·
3,296 Posts
Discussion Starter · #8 ·
Wow, stonewall has great prices!

thanks for the tip

tk
 
1 - 3 of 3 Posts
Top