XCR Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
350 Posts
Discussion Starter · #1 ·
My trigger axis pin/rod keeps pretruding out of the receiver. Do you have to place the legs of the hammer spring "over" the trigger axis pins so that the legs of the spring rest in the notches of the axis spring?
 

·
Registered
Joined
·
6,835 Posts
Yeah, without looking at it I think that is what you need to do. Check out this thread here

http://xcrforum.com/index.php/topic,766.0.html

It has a schematic of the trigger assembly. I have also posted some other pics in the past that you might be able to find in my old posts. Try putting the legs up on the pin and see if that cures it.
 

·
Registered
Joined
·
5,623 Posts
Correct,the trigger pin has two notches,one on either side that the "legs" of the hammer spring rest in.If you take a punch and partially push the pin out you'll see one.AZ's pics are great,but it's hard to see the groove in the pin.Just try to center the pin as much as possible then pull up on the legs and sit them out as close to the side of the receiver as possible and they should just line themselves up.
 

·
Registered
Joined
·
350 Posts
Discussion Starter · #4 ·
thank you, that will do it.
 
1 - 4 of 4 Posts
Top