XCR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
351 Posts
Discussion Starter · #1 ·
I just got a Millet DMS-1 1-4 x 24mm. While it is only 24mm, the bell or eyepiece is 42mm and thus needs clearance off the rail. But I don't want to go too high because the XCR has a heigher rail height than an AR when using the tubular folding stock. I need some 30mm ring mounts for it. I have seen several XCR's on this forum that are using this same scope, what rings and height are you guys using?

Should I go for Medium (1/2") height rings or high (3/4") rings? Looking at this great deal on Burris Xtreme 30mm rings: http://www.swfa.com/c-633-burris-xtreme-tacitcal-30mm-rings.aspx



 

·
Banned
Joined
·
8,010 Posts
1/2" will give you enough clearance.
 
1 - 3 of 3 Posts
Top